Network Technologies 900GV Manual do Utilizador descarregar pdf (Página 36)

Assigning an IP Address

4-2 Configuring the Module in a DIGITAL MultiSwitch 900

Assigning an IP Address

After installing the module in a DIGITAL MultiSwitch 900 chassis and connecting the

cables, you need to assign an IP address. Do this using the command line interface,

which is accessed through a terminal connected to the setup port on the MultiSwitch

900 chassis.

NOTE

The VNbus does not connect to the backplane by default. The VNbus is

configured using the clearVISN MultiChassis Manager.

To perform a Telnet session, you must assign an IP address. To do this, complete the

following steps:

Step Action

1 Install the module into a slot on the DIGITAL MultiSwitch 900.

2 Redirect the DIGITAL MultiSwitch 900 Chassis Manager setup port to

the DIGITAL VNswitch 900GV slot.

3 Select the IP Configuration option from the menu.

4 Set the in-band IP address.

5 Set the default gateway, if necessary.

6 Return to the VNswitch 900GV INSTALLATION MENU and select

[2] Restart with Current Settings.

7 Open a Telnet session into the module from the management station for

further configuration. The system displays copyright statements and the

following prompt:

After the system prompt (Main>) appears, refer to the DIGITAL

VNswitch 900 Series Switch Management for further configuration

information.

MOS Operator Control

Main>

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 71 72

Sem comentários

Network Technologies 900GV Manual do Utilizador Página 36